Rohde & Schwarz FSW26 - Page 719

Remote Commands
R&S
®
FSW
719User Manual 1173.9411.02 ─ 19
Parameters:
<Name> String containing the name of the channel
Example:
POW:ACH:SBL2:NAME:CHAN2?
Result:
'B:WCDMA'
Usage: Query only
Manual operation: See "Tx Channel Definition" on page 166
[SENSe:]POWer:ACHannel:SBLock<sb>:RFBWidth <Bandwidth>
This command defines the bandwidth of the individual MSR sub block. Note that sub
block ranges also affect the position of the adjacent gap channels (CACLR).
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<Bandwidth> Bandwidth in Hz
Manual operation: See "RF Bandwidth" on page 166
[SENSe:]POWer:ACHannel:SBLock<sb>:TECHnology[:CHANnel<ch>]
<Standard>
This command defines the technology used for transmission by the specified MSR Tx
channel.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Configuring and Performing Measurements