Rohde & Schwarz FSW26 - Page 720

Remote Commands
R&S
®
FSW
720User Manual 1173.9411.02 ─ 19
Parameters:
<Standard> GSM | WCDMa | LTE_1_40 | LTE_3_00 | LTE_5_00 |
LTE_10_00 | LTE_15_00 | LTE_20_00 | USER
Technology used for transmission
GSM
Transmission according to GSM standard
WCDMa
Transmission according to W-CDMA standard
LTE_1_40 | LTE_3_00 | LTE_5_00 | LTE_10_00 | LTE_15_00 |
LTE_20_00
Transmission according to LTE standard for different channel
bandwidths
USER
User-defined transmission; no automatic preconfiguration possi-
ble
Manual operation:
See "Technology Used for Transmission" on page 167
[SENSe:]POWer:ACHannel:SBLock<sb>:TXCHannel:COUNt <Number>
This command defines the number of transmission channels the specific sub block
contains.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<Number> Range: 1 to 18
*RST: 1
Manual operation: See "Number of Tx Channels (Tx Count)" on page 166
[SENSe:]POWer:ACHannel:SPACing:GAP<gap> <Spacing>
This command defines the distance from sub block to the specified gap channel.
The channels in the upper gap are identical to those in the lower gap. Thus, in the
R&S FSW MSR ACLR measurement, only 2 gap channels are configured.
The spacing for gap channels is defined in relation to the outer edges of the surround-
ing sub blocks, i.e.
Spacing = [CF of the gap channel] - [left sub block center] + ([RF bandwidth of left sub
block] /2)
(See also figure 5-24 and figure 5-25.)
Configuring and Performing Measurements