Remote Commands
R&S
®
FSW
790User Manual 1173.9411.02 ─ 19
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak[:STATe] <State>
This command turns the evaluation to determine the positive peak time domain power
on and off.
The R&S FSW performs the measurement on the trace marker 1 is positioned on.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Results" on page 267
CALCulate<n>:
MARKer<m>:FUNCtion:SUMMary:RMS[:STATe] <State>
This command turns the evaluation to determine the RMS time domain power on and
off.
The R&S FSW performs the measurement on the trace marker 1 is positioned on.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Results" on page 267
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation[:STATe] <State>
This command turns the evaluation to determine the standard deviation of the time
domain power on and off.
The R&S FSW performs the measurement on the trace marker 1 is positioned on.
Parameters:
<State> ON | OFF
*RST: OFF
11.5.9.2 Performing a Time Domain Power Measurement
The following commands are required to perform a Time Domain Power measurement:
INITiate[:IMMediate] on page 694, see chapter 11.5.1, "Performing Measure-
ments", on page 692
11.5.9.3 Retrieving Measurement Results
The following commands query the results for time domain measurements.
Configuring and Performing Measurements
To Next Page
Loading...
