Remote Commands
R&S
®
FSW
831User Manual 1173.9411.02 ─ 19
CALCulate<n>:MARKer<m>:FUNCtion:CSTep
This command matches the center frequency step size to the current marker fre-
quency.
The command turns delta markers into normal markers.
Usage: Event
DISPlay[:WINDow<n>]:TRACe:X:SPACing <ScalingType>
This command selects the scaling of the x-axis.
Parameters:
<ScalingType> LOGarithmic
Logarithmic scaling.
LINear
Linear scaling.
*RST: LINear
Example:
DISP:TRAC:X:SPAC LOG
Manual operation: See "Frequency Axis Scaling" on page 303
[SENSe:]FREQuency:CENTer <Frequency>
This command defines the center frequency.
Parameters:
<Frequency> The allowed range and f
max
is specified in the data sheet.
UP
Increases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP command.
DOWN
Decreases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP command.
*RST: fmax/2
Default unit: Hz
Example:
FREQ:CENT 100 MHz
FREQ:CENT:STEP 10 MHz
FREQ:CENT UP
Sets the center frequency to 110 MHz.
Usage: SCPI confirmed
Manual operation: See "Center frequency" on page 388
See "Frequency" on page 427
Setting Basic Measurement Parameters
To Next Page
Loading...
