Rohde & Schwarz SMC100A - Page 328

Remote Control Commands
R&S
®
SMC100A
313Operating Manual 1411.4060.32 ─ 09
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL.............................................................316
[:SOURce<hw>]:POWer:LIMit[:AMPLitude].......................................................................316
[:SOURce<hw>]:POWer:LMODe..................................................................................... 317
[:SOURce<hw>]:POWer:MANual.....................................................................................317
[:SOURce<hw>]:POWer:MODE.......................................................................................318
[:SOURce<hw>]:POWer:POWer......................................................................................318
[:SOURce<hw>]:POWer:SPC:CRANge............................................................................ 319
[:SOURce<hw>]:POWer:SPC:DELay............................................................................... 319
[:SOURce<hw>]:POWer:SPC:PEAK................................................................................ 320
[:SOURce<hw>]:POWer:SPC:SELect.............................................................................. 320
[:SOURce<hw>]:POWer:SPC:STATe...............................................................................320
[:SOURce<hw>]:POWer:SPC:TARGet............................................................................. 320
[:SOURce<hw>]:POWer:STARt.......................................................................................321
[:SOURce<hw>]:POWer:STEP[:INCRement].................................................................... 321
[:SOURce<hw>]:POWer:STEP:MODE............................................................................. 322
[:SOURce<hw>]:POWer:STOP........................................................................................322
[:SOURce<hw>]:POWer:ALC:OMODe <OffMode>
The command sets the level control mode which becomes active when automatic level
control is deactivated (ALC Off).
Parameters:
<OffMode> SHOLd
SHOLd
Level control is activated briefly if the level or frequency changes
("ALC Off Sample & Hold").
*RST: SHOLd
Example:
POW:ALC OFF
deactivates automatic level control for RF output A.
POW:ALC:OMOD SHOL
level control is briefly activated if the frequency or level changes.
[:SOURce<hw>]:POWer:ALC:SONCe
Temporarily activates level control for correction purposes.
Example:
POW:ALC OFF
deactivates automatic level control for RF output A.
POW:ALC:SONC
level control is performed once only.
Usage: Event
Manual operation: See "Search Once - ALC" on page 135
[:SOURce<hw>]:POWer:ALC[:STATe] <State>
Activates/deactivates automatic level control.
SOURce Subsystem