Rohde & Schwarz SMW-K144 - Page 27

5G New Radio Configuration and Settings
R&S
®
SMW-K144
27User Manual 1178.8013.02 ─ 06
Example test signals
Test signals are descriptions of specific 5G NR signals.
The following DL signals are provided:
●
"Example 100MHz Full Sub6GHz"
"Channel Bandwidth = 100 MHz", "Deployment = Sub 6 GHz",
"Number of BWPs = 1", "Subcarrier Spacing = 30 kHz", "PBCH >
Positions = 1100", "PDSCH > Modulation = QPSK, Type A",
"CORESET > No. Symb = 1".
●
"Example 100MHz 2BWP mmWave"
"Channel Bandwidth = 100 MHz", "Deployment = > 6 GHz",
"Number of BWPs = 2", "PBCH > Positions = 1100...", "PDSCH >
Modulation = QPSK, Type A", "CORESET > No. Symb = 1",
"Number of Users = 2", "Dummy RE > State > Off", where:
– BWP#1: "Subcarrier Spacing = 120 kHz"
– BWP#2: "Subcarrier Spacing = 60 kHz"
●
"Example 400MHz Full mmWave"
"Channel Bandwidth = 400 MHz", "Deployment = > 6 GHz",
"Number of BWPs = 1", "Subcarrier Spacing = 120 kHz", "PBCH
> Positions = 1100...", "PDSCH > Modulation = 256QAM, Type
A", "CORESET > No. Symb = 1"
The following UL signals are provided:
●
"Example 100MHz Full Sub6GHz"
"Channel Bandwidth = 100 MHz", "Deployment = Sub 6 GHz",
"Number of BWPs = 1", "Subcarrier Spacing = 30 kHz", "PUSCH
> Modulation = QPSK, Type A", "Transform Precoding = Off".
●
"Example 100MHz Full TP Sub6GHz"
"Channel Bandwidth = 100 MHz", "Deployment = Sub 6 GHz",
"Number of BWPs = 1", "Subcarrier Spacing = 30 kHz", "PUSCH
> Modulation = QPSK, Type A", "Transform Precoding = On".
Select a filename to observe summary information on the file content.
Remote command:
[:SOURce<hw>]:BB:NR5G:SETTing:TMODel:DL:CATalog? on page 165
[:SOURce<hw>]:BB:NR5G:SETTing:TMODel:DL on page 165
General Settings