5
Part of
Practice
133
Fully Utilizing Cutting Function
Hints and Tips for Cutting Setting
Setting the [PREFEED] menu item to “ENABLE” makes the machine automatically feed out
media and take it up again before cutting. This makes it unnecessary to run out media to the
rear of the machine before the operation.
P. 133, "Preventing Pulling of the Media with Undue Force When Performing Cutting Only"
The tip of the blade holder cap may scrape, and soil or damage the printed surface. If this
happens, increase the amount of blade extension.
P. 136, "Accurately Adjusting the Cutting-in Amount"
Preventing Pulling of the Media with Undue Force When Performing Cutting Only
Procedure
Press to display the left gure.
Press
.
Press to display the left gure.
Press
.
Press to select “ENABLE.”
Press
to enable the setting.
Press in this order to go back to the
original screen.
Description
This feeds out media according to the size of the data sent from the computer before performing cutting.
Therefore, the media does not have to be hanged down manually before every cutting operation.
Note, however, that this feeds out media even when you're performing printing only, so set it to "DISABLE"
when not needed
Default Setting
[PREFEED]: DISABLE
To Next Page
Loading...
