166
7
FAQ
The Machine Doesn’t Run
The Printer Unit Doesn't Run
Is the power switched on?
Switch on the printer's main power, then press the sub power switch and make sure the sub power switch
lights up.
P. 35, “Switch On”
Is illuminated?
Output is not performed when is not illuminated. Pull back the loading lever, close the front cover,
and press
.
Is the cover open?
Close front cover, side cover, and maintenance cover.
Is the top menu displayed?
Top menu
If the top menu isn't displayed, output doesn't start even when data is sent from
the computer. To go to the top menu, press
, then press .
P. 73, "Getting Ready to Receive Data from a Computer”
Is illuminated?
When lights up, operation is paused. To resume, press . goes dark and outputting
resumes.
P. 75, "Pausing and Canceling Output"
Has ink run out?
When printing data is sent while the screen shown in the gure is displayed,
a message appears and a warning beep sounds. At the same time, operation
pauses. When the ink cartridge is replaced with a new one, printing or cutting
starts.
P. 91, "How to Replace Ink Cartridges," p. 158, " Determining What Happens When
Ink Runs Out"
Is a message displayed on the screen?
P. 180, "A Message Appears," p. 182, "An Error Message Appears"
Is the cable connected?
Connect the cable securely.
"Setup Guide"
To Next Page
Loading...
Need help?
General