2
Basic
Operation
Outputting
69
Important Note on Cutting
When you’re performing cutting only, never use the media clamps.
When you’re performing cutting only, remove the media clamps or move to the locations where they don’t
clamp the media.
When you’re performing cutting only using the roll media, never allow the media to hang
down from the rear of the machine. (or set the [PREFEED] menu to “ENABLE.”)
This prevents a motor error or fall of the roll because the media is pulled with excessive force.
For the [PREFEED] menu, refer to p. 133, "Preventing Pulling of the Media with Undue Force When Performing
Cutting Only."
Push here.
Pull back while holding down the area.
Turn the media by hand to pull out the necessary length from
the roll. If the media is hanged down from the rear of the ma-
chine, you can leave the [PREFEED] function “DISABLE.”
To Next Page
Loading...
