5
Part of
Practice
Performing Printing and Cutting Separately
149
Correcting Misalignment for Printing and Cutting When Using Crop Marks
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBURA-
TION] to “0.00%.”
P. 139, "Performing Distance Correction During Cutting"
Procedure
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
P. 143, “Viewing the Automatic Environment Correction Function Setting"
Perform bidirectional adjustment.
P. 125, " Correcting for Misalignment in Bidirectional Printing," p. 126, "Correcting for Misalignment in Bidirectional
Printing More Precisely"
Press .
Press several times to display the left gure.
Press
, and then .
Press .
Press .
The test pattern (C&C1) is printed and cut.
When adjustment is needed, go on to the next Proce-
dure.
About Align Points
The numbers for align points are determined with reference to the location of the base point. You
cannot set an align point unless you specify a base point. Redoing the setting for the base point clears
any align points that have been set.
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
Printing position and Cutting posi-
tion are misaligned.
Printing position and Cutting posi-
tion are aligned.
Printing
position
Cutting
position
To Next Page
Loading...
Need help?
General