2
Basic
Operation
Outputting
74
Starting Output
When the operation of page 73 "Getting Ready to Receive Data from a Computer" is completed, you can start
output. To output, the following procedure is required.
Creating Output Data
Create the output data using the application software like Adobe Illustrator and like that. For information on
how to create the data, refer to the documentation of your application software.
Sending the Output Data to This Machine Using the Software RIP.
Use the included software RIP “Roland VersaWorks." For information on how to install and use Roland Versa-
Works, refer to “Roland VersaWorks Quick Start Guide” and HELP of Roland VersaWorks. If using the white ink
and gloss ink, refer to “White & Gloss Ink Guide.”
Points that must be observed
Be sure to mount the media clamps when printing on the media which is less than 0.5mm thick.
Otherwise the edges of the media may warp and catch on the print head.
During output, never touch the media. Doing so may obstruct media feed or cause the media to
rub against the heads, which may result in a paper jam or damage to the heads.
Keep the loading lever raised when the machine is not in use.
If Ink Runs Out
When ink runs out, a warning beep sounds and a slot number of which ink runs out is displayed on
the display screen.
P. 91, "How to Replace Ink Cartridges"
Before you perform lengthy printing, check the amount of ink remaining in the ink car-
tridges.
Before you perform lengthy printing, check the amount of ink remaining in the ink cartridges. When ink
runs out and printing is paused, the coloring at the seam may be altered when printing resumes.
P. 90, "Checking for Remaining Ink"
To Next Page
Loading...
Need help?
General