5
Part of
Practice
Fully Utilizing Cutting Function
139
Performing Distance Correction During Cutting
* When you’re performing printing followed by cutting, be sure to set the correction value to “0.00%.” Other-
wise the printing and cutting positions may become misaligned
Procedure
Press .
Press several times until the screen shown on
the left appears.
Press
.
Press
twice.
Press twice.
Press to select a correction value.
Set the correction value of media feed direction.
Press to enable the setting.
Press
and then .
Press .
Press to select a correction value.
Set the correction value of head movement direction.
Press to enable the setting.
Press in this order to go back to the
original screen.
Description
The movement distance of the media changes subtly depending on the media's thickness. This means that
the length of a line when cut may dier from the length setting in the data. You enter a correction value when
you want to align the lengths
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
To Next Page
Loading...
