173
7
FAQ
Media Jam Occurs
The Media Jams
If an error message is displayed because the media has jammed, immediately correct
the problem. Failure to do so may damage the print head.
P. 184, [MOTOR ERROR TURN POWER OFF]
Is the media warped or wrinkled?
Many factors can cause warping or wrinkling. Refer to the following and correct the problem.
P. 175, "Media Feed is Not Smooth"
Is the height of the print head too low?
Try raising the heads higher. Media may inevitably warp or wrinkle slightly, so adjust the height of the heads
to take this into account.
P. 128, "Adjusting Head Height to Match Media Thickness"
To Next Page
Loading...
Need help?
General