4
Mainte-
nance
Replacing Consumable Parts
114
Press .
After the process to quit the wiper replacement mode, the screen
shown in the gure appears.
Press in this order to go back to the
original screen.
4.
Perform a printing test to verify the results of the procedure.
Perform a printing test to check the result.
P. 67, "Printing Tests and Normal Cleaning"
Replacing the Blade
If the blade becomes dull, or if the edge of the blade is chipped, or if the blade quality is lowered, replace it
with a new blade.
CAUTION
Be sure to perform operations as specied by these instructions, and
never touch any area not specied in the instructions.
Sudden movement of the machine may cause injury.
CAUTION
Never touch the tip of the blade with your ngers.
Doing so may result in injury.
1.
Enter the blade replacement menu.
Press .
Press several times until the screen shown on
the left appears.
Press
and then .
Press .
Press
twice.
Press .
The cutting carriage moves to a location permitting blade replace-
ment, and then the screen shown in the gure appears.
To Next Page
Loading...
