180
7
FAQ
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any error. Follow the prompts and take action accordingly.
[1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6 ■]
Only a small amount of ink remains. Replace the cartridge indicated by the ashing number with a new
cartridge.
[PRESS THE POWER KEY TO CLEAN]
This appears when the machine has been unused for about one month. Switch on the sub power once a
month.
P. 119, "When Not in Use for a Prolonged Period"
[CIRCULATING INK]
The white ink is being circulated inside the machine. This is automatically performed to clear the precipitation
of the white ink. Wait until the displayed message changes.
[SET CARTRIDGE]
Insert the ink cartridge indicated by the ashing number. This message appears at times such as during ink
cartridge replacement.
[REMOVE CARTRIDGE]
Remove the ink cartridge indicated by the ashing number. This message appears at times such as during
ink cartridge replacement.
[CLOSE THE COVER (FRONT COVER, SIDE COVER or MAINTENANCE COVER]
Close the front cover, side cover, maintenance cover. For safety, the carriage does not operate while a cover
is open.
[SET CL-LIQUID]
Insert the SOL INK cleaning cartridge indicated by the ashing number. This message appears at times such
as during head cleaning.
[REMOVE CL-LIQUID]
Remove the SOL INK cleaning cartridge indicated by the ashing number. This message appears at times such
as during head cleaning.
[END OF THE SHEET]
The trailing edge of the media was detected during operation. Press any button on the operation panel to
clear the message. Load new media.
[SHEET NOT LOADED PRESS SETUP KEY]
Load media and press . This message appears when an attempt to perform a printing test was made
while no media was loaded.
To Next Page
Loading...
