A Message Appears
7
FAQ
181
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, then press .
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged uid collects in the drain bottle. To clear the message,
press
. If this screen appears, go to the [DRAIN BOTTLE] menu and discard the discharged uid in
the bottle.
P. 95, "Disposing of Discharged Ink"
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height specied on the computer. The heads move to a location
where you can operate the height-adjustment lever. Adjust to the displayed height, then press
.
[REMOVE MEDIA CLAMPS]
This appears when media cuto is attempted without rst removing the media clamps. The media cuto
starts when
is pressed after the media clamps are removed. Pressing while this message
is displayed quits cuto.
[TIME FOR MAINTENANCE]
The time has come to perform the manual cleaning. After verifying, press .
P. 102, “Performing Manual Cleaning”
[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press .
P. 111, "Replacing the Wiper"
To Next Page
Loading...
Need help?
General