Roland LEC-540 User Manual

5
Part of Practice
Fully Utilizing Cutting Function
140
Correcting Misalignment of the Printing and Cutting Positions
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBURA-
TION] to “0.00%.”
 P. 139, "Performing Distance Correction During Cutting"
Procedure

Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
P. 143, "Viewing the Automatic Environment Correction Function Settings"

Perform bidirectional adjustment.
P. 125, " Correcting for Misalignment in Bidirectional Printing," p. 126, "Correcting for Misalignment in Bidirectional
Printing More Precisely"

Press .

Press to display the left gure.
Press
.

Press .

Press .
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
When adjustment is needed, go on to the next Proce-
dure.

Press to display the left gure.
Press
.
The test pattern (P&C2) is printed and cut.
For information on the method of test pattern check, refer to the next page.
MENU
CUTTING MENU
CUTTING MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
PRINT - CUT ADJ.
TEST PRINT 2
Printing position and Cutting posi-
tion are misaligned.
Printing position and Cutting posi-
tion are aligned.
Cutting
position
Printing
position

Roland LEC-540 Specifications

General

Brand	Roland
Model	LEC-540
Category	Printer
Language	English