Fully Utilizing Preset Function
5
Part of
Practice
123
[PRINT-CUT ADJ.] P. 140, "Correcting Misalignment of the Printing
and Cutting Positions"
[CROP-CUT ADJ.] P. 149, "Correcting Misalignment for Printing
and Cutting When Using Crop Marks"
P. 123, "Loading a Saved Preset," p. 123, "Assigning a Name to a Preset"
Loading a Saved Preset
Procedure
Press .
Press to display the left gure.
Press
twice.
Press to select a name to be called.
Press
to enable the setting.
The settings are changed and the screen shown in the gure ap-
pears.
Description
This loads a saved preset. You can select any one of eight types of presets. (When no names have been assigned,
you select from among NAME1 through NAME8.) If you load a preset while
is illuminated,
goes dark. When starting output, press again to make the output operation available.
Assigning a Name to a Preset
Procedure
Press .
Press to display the left gure.
Press
and then .
Press .
Press to select one of NAME1 through
8.
Press
.
Continued on the next page.
To Next Page
Loading...
