5
Part of
Practice
Performing Printing and Cutting Separately
148
Aligning Manually and Cutting
Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks
cannot be detected automatically, you perform alignment manually.
1.
Set the base point.
Press to
align the center of the blade with the loca-
tion shown in the gure.
Press .
2.
Set the align points.
Press to
align the center of the blade with the loca-
tion shown in the gure.
Hold down for one second or longer.
The number of the align point you set is automatically determined.
Press .
Repeat steps
through
to specify other align points as required.
Send the cutting data and perform cutting.
To Next Page
Loading...
Need help?
General