2
Basic
Operation
Outputting
71
The Cutting Test And Setting The Blade Force
For high-quality cutting, before you perform actual cutting, we recommend
carrying out a cutting test to check the cutting quality for the media. Adjust
the blade force depending on the cutting quality.
1.
Carrying out the cutting test
Press to move the cutting carriage to the location where
you want to carry out the cutting test.
You can freely set the location for the cutting test.
Close the front cover.
Press .
The test pattern is cut.
Peel off the cut shapes to verify the cutting quality.
[Two shapes are peeled off separately]
You do not need to perform the setting because the blade force is ap-
propriate.
[Two shapes are peeled off together/backing paper is also
cut]
Go to the next Procedure to set the blade force.
2.
Setting the blade force.
Press .
Press to select the value.
[Two shapes are peeled off together]
Raise the blade force.
[Backing paper is also cut]
Reduce the blade force.
Press .
The setting is nished, and the original screen appears.
At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade
force. Refer to the following pages.
P. 134, "Fine-tuning the Cutting Conditions"
Continued on the next page
To Next Page
Loading...
Need help?
General