Roland LEC-540 - Switching the Ink Type

5
Part of Practice
Performing Printing and Cutting Separately
150

Press to display the left gure.
Press
.
The test pattern (C&C2) is printed and cut.

Press to display the left gure.
Press
.

Press to select a correction value of [F]
(feed direction of media).
Press
to select a correction value of [S]
(movement direction of head).
Press
to enable the setting.

Press in this order to display the left
gure.
Press
.
The test pattern (C&C1) is printed and cut. If the printing and cutting
lines are aligned, adjustment is complete.If further adjustment is
needed, go back to Procedure

and ne-tune the adjustment.
CROP - CUT ADJ.
TEST PRINT 2
To check the test pattern (C&C2)
The point where the cutting line intersects the correction-value scale is the correction value. In this
gure, the value is "-0.3." Use the same method to read the value on the feed direction.
CROP - CUT ADJ.
SETTING
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
CROP - CUT ADJ.
TEST PRINT
Cutting
position
Printing position and Cutting position
are aligned.
Printing
position
Scan direction
Feed direction
Correction-value scale
Cutting
line
In this gure, the value
is "-0.3."
Cutting line