Roland VR-6HD

31
Video Operations
Freezing the Input Video (Freeze)
Here’s how to temporarily freeze the input video (freeze function).
You can apply transition eects during a video freeze.
Setting the Operation Mode
There are two freeze modes: the “ALL mode” for freezing all input video,
and the “SELECT mode” that freezes only the input video you specify. Set
the mode that matches your needs.
1. [MENU] button
Ó
“VIDEO”
Ó
select “FREEZE”, and press the
[VALUE] knob.
The Freeze function setup screen appears.
2. Use the [VALUE] knob to select “TYPE”, and then press the
[VALUE] knob.
3. Use the [VALUE] knob to select the operation mode, and
press the [VALUE] knob.
Value Explanation
ALL Freezes all video that is being input.
SELECT Freezes only the specied input video.
If “SELECT” is selected
4. Touch the screen to specify “VIDEO 1” through “VIDEO 6”.
Value Explanation
ENABLE The input video freezes.
DISABLE The input video does not freeze.
5. Press the [MENU] button to close the screen.
Freezing the Input Video
1. [MENU] button
Ó
“VIDEO”
Ó
select “FREEZE”, and press the
[VALUE] knob.
The Freeze function setup screen appears.
2. Use the [VALUE] knob to select “FREEZE”, and then press the
[VALUE] knob.
3. Use the [VALUE] knob to select “ON”.
The input video freezes.
4. To turn the freeze function o, operate the [VALUE] knob
again and select “OFF”.
5. Press the [MENU] button to close the screen.
MEMO
You can assign the freeze function to a USER button on the
dashboard to turn the function on/o (p. 84).