Roland VR-6HD

78
Other Functions
Running the Sequencer
Press the button to make the functions recorded in the sequencer
execute one at a time.
1. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“SEQUENCER”, and press the [VALUE] knob.
The setup screen appears.
2. Use the [VALUE] knob to select “SEQUENCER”, and then
press the [VALUE] knob.
3. Use the [VALUE] knob to select “ON”.
4. Press the [MENU] button to close the screen.
Shows the sequencer execution screen.
To edit screen
Maximize/minimize
5. Press the [AUTO] (NEXT) button.
The rst function in the list is executed.
The button blinks while the function is executing. When the function
ends, the button remains lit.
6. Press the [AUTO] (NEXT) button at the timing when you
want the next function to execute.
The function is executed.
[CUT] (PREVIOUS) button
Press the [CUT] button if you want to return to the state at which the
previous function was completed.
MEMO
You can also touch <NEXT> or <PREVIOUS> on the screen to
operate the sequencer.
7. Repeat step 6.
8. Using the operations in steps 1–3 again, turn the sequencer
function o by setting SEQUENCER to “OFF”.
MEMO
Repeatedly executing a function in the list
You can repeatedly execute functions that are in a list. Once the last
function is nished, press the [AUTO] button to execute the function
at the beginning of the list.
From the [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
“SEQUENCER”
Ó
set “REPEAT EXECUTE” to “ON”.
Executing a function from the middle of the list
When you directly touch a line corresponding to the desired operation in
the list, the operation for that line switches to a completed state. You can
press the [AUTO] button to execute the next operation afterwards.