Roland VR-6HD

80
Other Functions
Saving/Loading the Sequencer Settings
You can save the sequencer settings as a single le (.RSQ) to a storage (SD card, USB ash drive) connected to the VR-6HD.
You can access the saved sequence le on the storage and load it into the unit for use when needed.
NOTE
¹ When using a SD card or USB ash drive for the rst time, you
must format it using the VR-6HD (p. 13).
¹ Never turn o the power or remove the SD card or USB ash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB ash drive, it may take some
time to be recognized.
¹ Sequence les are saved to the “Roland/VR-6HD/sequencer”
folder.
Saving a new le
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“SEQUENCER”, and press the [VALUE] knob.
The setup screen appears.
3. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
The sequence les in the storage are listed.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
4. Select “FILE NAME” and press the [VALUE] knob.
This brings up the software keyboard for input.
5. Input the backup le name.
* You can input up to 32 characters.
6. Touch <Enter> in software keyboard.
7. When you have nished entering the le name, use the
[VALUE] knob to select “SAVE”, and then press the [VALUE]
knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
8. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The sequence le (.RSQ) is saved to the storage. When the operation is
nished, the message “COMPLETED” appears.
9. Press the [MENU] button to close the menu.
Overwrite-saving
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“SEQUENCER”, and press the [VALUE] knob.
The setup screen appears.
3. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
4. Touch the sequence le that you want to overwrite.
The lename shown in the list of lenames is used.
5. Use the [VALUE] knob to select “SAVE”, and then press the
[VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
6. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The sequence le is overwritten. When the operation is nished, the
message “COMPLETED” appears.
7. Press the [MENU] button to close the menu.