Roland VR-6HD

48
Audio Operations
Applying Eects to Output Audio
Here’s how to modify the tonal character by applying eects.
The following table shows the eects that are available.
Audio bus Reverb Equalizer Delay
Compressor/
Limiter
Graphic
Equalizer
Adaptive
NR
Loudness
AGC
MAIN BUS
µ µ µ µ µ µ µ
AUX BUS 1
AUX BUS 2
µ µ µ µ µ
— —
USB OUT
—
µ µ
— — — —
STREAM/
RECORD
—
µ µ
— — — —
1. Press the MAIN [SETUP] button.
The AUDIO OUTPUT screen appears.
2. Touch the <SETUP> icon of the bus you want to adjust.
The setup screen appears for the bus you selected.
3. Touch the screen to access the settings.
* For details on the parameter, refer to “2: AUDIO” (p. 99).
4. Press the lit [SETUP] button to close the setup screen.
ÁEqualizer
This is a four-band equalizer. It lets you shape the character of
the sound by boosting or cutting four frequency regions.
ÁDelay
Outputs audio with a delay. Delaying the output lets you
correct timing problems in the audio signal that is input to the
output destination device.
ÁCompressor/Limiter
Compresses audio levels that exceed the threshold you set, or
limits the output level so that it does not exceed the threshold.
ÁGraphic Equalizer
It lets you shape the character of the sound by boosting or
cutting each of the 15 frequency regions into which the sound
is divided.
ÁAdaptive Noise Reduction (p. 49)
By continuously monitoring the input audio to detect
noise during periods of silence, this removes only the noise
component.
ÁLoudness Auto Gain Control (p. 50)
The long-term average loudness is measured, and the volume is
adjusted so that it is appropriate overall.
Interlinking Audio Output to Video
Switching (Audio Follow)
Here’s how the audio output can be automatically switched in tandem
with video switching (the audio follow function).
1. [MENU] button
Ó
“AUDIO”
Ó
select “AUDIO FOLLOW”, and
press the [VALUE] knob.
2. Use the [VALUE] knob to select the input video that uses
audio follow.
Use “ALL AUDIO
FOLLOW” to edit
the settings all at
once.
3. Press the [VALUE] knob to turn it “ON”.
Value Explanation
ON
The audio is output only when the video is selected.
The audio is automatically muted if another video
is selected.
OFF
The audio is always output regardless of the video
selection.
4. Press the [MENU] button to close the menu.
Adding an Object for Audio Follow
You can set the audio from the AUDIO IN, USB IN or Bluetooth IN as the
object for Audio Follow.
1. From [MENU] button
Ó
“AUDIO”
Ó
select “AUDIO FOLLOW”
to choose the input audio to be the object of Audio Follow.
2. Use the [VALUE] knob to select one of “INPUT 1”–“INPUT 6”.
Value Explanation
VIDEO 1–6
STILL 1–16
V.PLAYER
INPUT 1–6
For each audio source, these settings specify the
input video that will use the audio follow function.
Audio is output only when the specied input video
is selected.
OFF
The audio is always output regardless of the video
selection.
3. Press the [MENU] button to close the menu.
MEMO
You can synchronize the audio with the on/o state of the PinP &
KEY or DSK. (p. 138)