Roland VR-6HD

75
Other Functions
Loading
Here’s how to load the macro settings that are saved on a storage.
Loading the settings overwrites the current settings for the macros
(1–100).
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“MACRO”, and press the [VALUE] knob.
The macro screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “LOAD FROM STORAGE”, and
press the [VALUE] knob.
The macro setting les in the storage are listed.
* Use the “SD CARD” or “USB MEMORY” selector at the top of the screen
to switch between the storage media to load from.
5. Touch the macro settings le that you want to recall.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
6. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The macro settings are loaded. When the operation is nished, the
message “COMPLETED” appears.
7. Press the [MENU] button to close the menu.
Initializing All Macros
Here’s how to initialize and erase all the macros.
1. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“MACRO”, and press the [VALUE] knob.
The macro screen appears.
2. Touch <SETUP>.
The setup screen appears.
3. Use the [VALUE] knob to select “INITIALIZE”, and then press
the [VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
4. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The macros are initialized.
5. Press the [MENU] button to close the menu.