Roland VR-6HD

67
Other Functions
Changing the Thumbnail Position
You can change the position of the thumbnail used for checking the
video/image content, shown on the scene memory setup screen.
1. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
“ SCENE
MEMORY ”
Ó
select “ 8VIEW ”, and press the [VALUE] knob.
The scene memory screen appears.
2. Long-press the area of the scene memory whose thumbnail
you want to change.
A popup menu appears.
3. Touch <THUMBNAIL>.
This shows the thumbnail layout screen.
4. Touch the screen to access the settings.
5. Press the [EXIT] button.
Saving Scene Memories to a USB Flash Drive
You can save the scene memories (1–32) as a single le (.VR6SCENE)
to a storage media (SD card or USB ash drive) that’s connected to the
VR-6HD. This lets you access saved scene memory les on the storage
media and load them to use as needed.
NOTE
¹ When using a SD card or USB ash drive for the rst time, you
must format it using the VR-6HD (p. 13).
¹ Never turn o the power or remove the SD card or USB ash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB ash drive, it may take some
time to be recognized.
¹ The scene memory le is saved to the “Roland/VR-6HD/scene_
memory” folder.
Saving a new le
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select “ SCENE
MEMORY ”, and press the [VALUE] knob.
The scene memory screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
This shows a list of scene memory les on the storage media.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
5. Select “FILE NAME” and press the [VALUE] knob.
This brings up the software keyboard for input.