Roland VR-6HD

25
Video Operations
Loading a Still Image
You can load a still image, and output it in the same way as video (p. 26) or use it as a source for DSK compositing (p. 35). There are two ways to load a
still image: you can load from storage media (either an SD card or a USB ash drive), or you can capture the image from the input video.
You can save up to sixteen still images in the unit.
* When still images are saved in the unit, startup takes longer time according to image size and the number of still images saved.
Loading a Still Image from a Storage
Here’s how to load a still image from a storage into the unit.
1. Save the still image in the root directory of the SD card or
USB ash drive.
2. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
3. [MENU] button
Ó
“STILL IMAGE”
Ó
select “LOAD FROM
STORAGE”, and press the [VALUE] knob.
4. Touch the screen to select the load destination memory
(STILL 1–16) for the still image.
A list of the still images in the storage is shown.
* Use the “SD CARD” or “USB MEMORY” selector at the top of the screen
to switch between the storage media to load from.
5. Touch the lename of the still image you want to load.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
6. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The still image is loaded into the unit. When the operation is nished,
the message “COMPLETED” appears.
7. Press the [MENU] button to close the menu.
MEMO
You can set the method of saving still images to “temporarily save”.
When you turn o the power, the loaded still image is deleted.
From the [MENU] button
Ó
“STILL IMAGE”, set “SAVE TO INTERNAL
STORAGE” to “DISABLE”, and then load the still image.
NOTE
¹ The still image is scaled to the output format size.
¹ When using a SD card or USB ash drive for the rst time, you
must format it using the VR-6HD (p. 13).
¹ Never turn o the power or remove the SD card or USB ash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB ash drive, it may take some
time to be recognized.
Formats supported for importing
Format
Bitmap le (.bmp), 24-bit color, uncompressed
PNG le (.png), 24-bit color
* Alpha channel supported
JPEG le (.jpg, .jpeg), 24-bit color
Resolution In conformity with system format (p. 14)
File name
No more than 64 single-byte alphanumeric characters
The extension “.bmp”, “.png”, “.jpg”, or “.jpeg” must be
added.