Roland VR-6HD

82
Other Functions
Backing Up and Restoring the Unit’s Settings
You can group together the unit’s settings into a single le (.VR6) and back up it to a storage (SD card, USB ash drive) connected to the VR-6HD. You can
access the backed up setting le on the storage and restore it into the unit for use when needed.
NOTE
¹ When using a SD card or USB ash drive for the rst time, you
must format it using the VR-6HD (p. 13).
¹ Never turn o the power or remove the SD card or USB ash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB ash drive, it may take some
time to be recognized.
¹ Backup les are saved to the “Roland/VR-6HD/backup” folder.
Backing Up
Saving a new le
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“SD CARD/USB MEMORY”
Ó
select
“BACKUP ALL SETTINGS”, and press the [VALUE] knob.
The backup les in the storage are listed.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
3. Select “FILE NAME” and press the [VALUE] knob.
This brings up the software keyboard for input.
4. Input the backup le name.
* You can input up to 32 characters.
5. Touch <Enter> in software keyboard.
6. Use the [VALUE] knob to select “SAVE”, and then press the
[VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
7. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The settings le (.VR6) is backed up on the storage. When the
operation is nished, the message “COMPLETED” appears.
8. Press the [MENU] button to close the menu.
MEMO
Some settings are not saved to the le, such as the “TEST PATTERN”
and “TEST TONE” settings in the SYSTEM menu.