Roland VR-6HD

74
Other Functions
Saving/Loading the Macro Settings
You can group together the macro settings (1–100) into a single le (.RMC) and save it to a storage (SD card, USB ash drive,) connected to the VR-6HD. You
can access the saved macro setting le on the storage and load it into the unit for use when needed.
NOTE
¹ When using a SD card or USB ash drive for the rst time, you
must format it using the VR-6HD (p. 13).
¹ Never turn o the power or remove the SD card or USB ash drive
while the message “PROCESSING...” is shown.
¹ Depending on the SD card or USB ash drive, it may take some
time to be recognized.
¹ Macro les are saved to the “Roland/VR-6HD/macro” folder.
Saving a new le
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“MACRO”, and press the [VALUE] knob.
The macro screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
The macro setting les in the storage are listed.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
5. Select “FILE NAME” and press the [VALUE] knob.
This brings up the software keyboard for input.
6. Input the backup le name.
* You can input up to 32 characters.
7. Touch <Enter> in software keyboard.
8. When you have nished entering the le name, use the
[VALUE] knob to select “SAVE”, and then press the [VALUE]
knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
9. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The macro settings le (.RMC) is saved to the storage. When the
operation is nished, the message “COMPLETED” appears.
10. Press the [MENU] button to close the menu.
Overwrite-saving
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select
“MACRO”, and press the [VALUE] knob.
The macro screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
The macro setting les in the storage are listed.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
5. Touch the macro settings le that you want to overwrite.
The lename shown in the list of lenames is used.
6. Use the [VALUE] knob to select “SAVE”, and then press the
[VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
7. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The macro settings le is overwritten. When the operation is nished,
the message “COMPLETED” appears.
8. Press the [MENU] button to close the menu.