Roland VR-6HD

68
Other Functions
6. Input the backup le name.
* You can input up to 32 characters.
7. Touch <Enter> in software keyboard.
8. When you have nished entering the le name, use the
[VALUE] knob to select “SAVE”, and then press the [VALUE]
knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
9. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The scene memory le (.VR6SCENE) is saved to the storage media.
When the operation is nished, the message “COMPLETED” appears.
10. Press the [MENU] button to close the menu.
Overwrite-saving
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select “ SCENE
MEMORY ”, and press the [VALUE] knob.
The scene memory screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “SAVE TO STORAGE”, and
then press the [VALUE] knob.
This shows a list of scene memory les on the storage media.
* You can use “TARGET STORAGE” onscreen to switch between the
storage media used for export.
5. Touch the scene memory le that you want to overwrite.
The lename shown in the list of lenames is used.
6. Use the [VALUE] knob to select “SAVE”, and then press the
[VALUE] knob.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
7. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The scene memory le is overwritten. When the operation is nished,
the message “COMPLETED” appears.
8. Press the [MENU] button to close the menu.
Loading
Here’s how to load the scene memory settings that are saved on storage
media. When you recall the settings, the current scene memory settings
are overwritten.
1. Insert the SD card into the SDXC card slot.
* When using a USB ash drive, connect the USB ash drive to the USB
HOST port.
2. [MENU] button
Ó
“MEMORY/MACRO/SEQ”
Ó
select “ SCENE
MEMORY ”, and press the [VALUE] knob.
The scene memory screen appears.
3. Touch <SETUP>.
The setup screen appears.
4. Use the [VALUE] knob to select “LOAD FROM STORAGE”, and
press the [VALUE] knob.
This shows a list of scene memory les on the storage media.
* Use the “SD CARD” or “USB MEMORY” selector at the top of the screen
to switch between the storage media to load from.
5. Touch the scene memory le that you want to recall.
A conrmation message appears.
* If you decide to cancel, press the [EXIT] button.
6. Use the [VALUE] knob to select “OK”, and then press the
[VALUE] knob.
The scene memory settings are loaded. When the operation is
nished, the message “COMPLETED” appears.
7. Press the [MENU] button to close the menu.