Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring STA Management
signals travel in the space. When E-bags are used in two adjacent classrooms at the same time, the ideal condition is that all
the teacher and student terminals are associated with the AP of their own classrooms so that the two classrooms will not
interfere with each other. In this case, a classroom must be defined as an association control zone and all the teacher and
student terminals in a classroom must be associated with the AP of the classroom.
Association control aims to prevent terminals from associating with a wireless network at random when multiple wireless
networks are available for selection. The following are prerequisites for network configurations:
 Based on the pre-configured association control zones and package information, the AC pushes the information about
primary STAs in all packages to all APs in the association control zones and generates a whitelist of primary STAs on
these APs.
 The information about primary STAs in all packages is available in the AP whitelist. Therefore, before the association
control function is enabled, the primary STA must associate itself with the corresponding SSID in the specified control
zone. After that, the AC pushes all corresponding secondary STAs to all APs in the association control zone and
generates a whitelist according to the configuration of the primary STA package to allow the secondary STAs to
associate themselves with the control zone.
 When the primary STA is de-associated from the control zone, all the secondary STAs will also be de-associated and
deleted from the AP whitelist.
 The above process can be summarized as follows: The secondary STAs must follow the primary STA to associate
themselves with an AP in the same control zone, with which the primary STA is associated. Only the APs of this control
zone have a whitelist of the corresponding secondary STAs. This ensures that STAs are not randomly associated with
APs.
2.4 Configuration
Configuration
Description and Command
Configuring Association
Control
(Mandatory) It is used to enable the association control function.
package
Configures a package.
primary-sta
Configures the primary STA in the
package.
secondary-sta
Configures the secondary STA in the
package.
control-zone
Configures an association control zone.
ap
Configures the AP information.
assoc-control
Enables association control.
2.4.1 Configuring Association Control
Configuration Effect
 Secondary STAs must be associated with APs in the same group as the primary STA when being associated.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English