Configuration Guide Configuring CLI
show any-command | exclude regular-expression
Filters the output of the show command. Except those
containing the specified contents, all lines will be output.
show any-command | include regular-expression
Filters the output of the show command. Only the lines
containing the specified contents will be output.
To search or filter the output of the show command, you must enter a vertical line (|). After the vertical line, select the
searching or filtering rules and contents (character or string). Searched and filtered contents are case sensitive.
Ruijie#show running-config | include interface
interface GigabitEthernet 0/0
interface GigabitEthernet 0/1
interface GigabitEthernet 0/2
interface GigabitEthernet 0/3
interface GigabitEthernet 0/4
interface GigabitEthernet 0/5
interface GigabitEthernet 0/6
interface GigabitEthernet 0/7
interface Mgmt 0
1.3.10 Command Alias
You can configure any word as the alias of a command to simply the command input.
Configuration Effect
1. Replace a command with a word.
For example, configure "mygateway" as the alias of the ip route 0.0.0.0 0.0.0.0192.1.1.1 command. To run this command,
you only need to enter "mygateway".
2. Replace the front part of a command with a word, and enter the later part.
For example, configure "ia" as the alias of the ip address command. To run this command, you need to enter "ia" and then
the specified IP address and subnet mask.
Configuration Steps
Displaying Default Alias
In User EXEC or Privileged EXEC mode, default alias are available for some commands. You can run the show aliases
command to display these default aliases.
Ruijie(config)#show aliases
Exec mode alias:
To Next Page
Loading...
