Ruijie RG-WLAN Series - Page 1036

Configuration Guide Basic Management
mode.
 Configuring the Session Timeout Time
Command
session-timeout minutes[ output ]
Parameter
Description
minutes: Indicates the session timeout time in the unit of minutes.
output: Indicates whether to add data output as a timeout criterion.
Command
Mode
Line configuration mode
Usage Guide
Use this command to configure the timeout time for the remote host sessions on a line. A session will be
disconnected when no input is detected during the timeout time.
To cancel the session timeout time, run the no session-timeout command in line configuration mode.
 Enabling Line-Based Terminal Lock
Command
lockable
Parameter
Description
N/A
Command
Mode
Line configuration mode
Usage Guide
N/A
 Locking a Terminal Connected to the Current Line
Command
lock
Parameter
Description
N/A
Command
Mode
Line configuration mode
Usage Guide
N/A
Configuration Example
 Establishing a Telnet Session to a Remote Network Device
Configuration
Steps
 Establish a Telnet session to a remote network device with the IP address 192.168.65.119.
 Establish a Telnet session to a remote network device with the IPv6 address 2AAA:BBBB::CCCC.
Ruijie# telnet 192.168.65.119
Trying 192.168.65.119 ... Open
User Access Verification
Password:
Ruijie# telnet 2AAA:BBBB::CCCC
Trying 2AAA:BBBB::CCCC ... Open