Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring SNMP
Configuration Steps
 Configuring the SNMP Host Address
 Optional
 Configure the host address of the NMS when the agent is required to actively send messages.
 Enabling the Agent to Actively Send a Trap Message to the NMS
 Optional
 Configure this item on the agent when the agent is required to actively send a trap message to the NMS.
 Enabling the Function of Sending a Link Trap Message on an Interface
 Optional
 Configure this item on the agent when a link trap message needs to be sent on an interface.
 Enabling the Function of Sending a System Reboot Trap Message
 Optional
 Configure this item on the agent when the RGOS system is required to send a trap message to the NMS to notify
system reboot before reloading or reboot of the device.
 Specifying the Source Address for Sending a Trap Message
 Optional
 Configure this item on the agent when it is required to permanently use a local IP address as the source SNMP address
to facilitate management.
 Enabling a Trap Message to Carry Private Fields when the Message Is Sent
 Optional
 Configure this item on the agent when private fields need to be carried in a trap message.
Verification
Run the show snmp command to display the SNMP status.
Run the show running-config command to display configuration information of the device.
Related Commands
 Setting the NMS Host Address
Command
snmp-server host { host-addr | ipv6 ipv6-addr } [ traps | inrorms ] [ version { 1 | 2c | 3 { auth | noauth |
priv } ] community-string [ udp-port port-num ] [ notification-type ]
Parameter
Description
host-addr: Address of the SNMP host.
ipv6-addr: (IPv6) address of the SNMP host.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English