Configuration Guide Configuring SNMP
Run the show running-config command to display configuration information of the device.
Related Commands
 Setting the System Contact Mode
text: String that describes the system contact mode.
Global configuration mode
 Setting the System Location
snmp-server location text
text: String that describes system information.
Global configuration mode
 Setting the System Serial Number
snmp-server chassis-id text
text: Text of the system serial number, which may be digits or characters.
Global configuration mode
In general, the device serial number is used as the SNMP serial number to facilitate identification of the
device.
 Setting NE Information about the Device
text: Text that is used to set the device NE code. The text is a string that consists of 1 to 255 characters that
are case-sensitive and may include spaces.
Global configuration mode.
Set the NE code of the device.
 Setting the Maximum Packet Length of the SNMP Agent
snmp-server packetsize byte-count
byte-count: Packet size, ranging from 484 bytes to 17,876 bytes.
To Next Page
Loading...
Need help?
General
