Ruijie RG-WLAN Series

Configuration Guide Configuring CWMP
Configuration
Steps
 Enable the CWMP function and enter CWMP configuration mode.
 Disable the CPE's function of uploading configuration and log files to the ACS.
CPE
Ruijie#config
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#cwmp
Ruijie(config-cwmp)# disable upload
Verification
Run the show command on the CPE to check whether the configuration commands have been
successfully applied.
CPE
Ruijie #show cwmp configuration
CWMP Status : enable
……
CPE upload status : disable
 Configuring the Backup and Restoration Delay
Network
Environment
See Figure 9-6.
Configuration
Steps
 Enable the CWMP function and enter CWMP configuration mode.
 Set the backup and restoration delay to 100 seconds.
CPE
Ruijie#config
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#cwmp
Ruijie(config-cwmp)# cpe back-up Seconds 30
Verification
 Run the show command on the CPE to check whether the configuration commands have been
successfully applied.
CPE
Ruijie #show cwmp configuration
CWMP Status : enable
……
CPE back up delay time : 30s
 Configuring the ACS Response Timeout of the CPE
Network
Environment
See Figure 9-6.