Ruijie RG-WLAN Series

Configuration Guide Configuring CWMP
Configuration
Steps
 Enable the CWMP function and enter CWMP configuration mode.
 Set the response timeout of the CPE to 100 seconds.
CPE
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# cwmp
Ruijie(config-cwmp)# timer cpe-timeout 100
Verification
 Run the show command on the CPE to check whether the configuration commands have been
successfully applied.
CPE
Ruijie#show cwmp configuration
CWMP Status : enable
……
CPE wait timeout : 100s
Common Errors
N/A
9.4 Monitoring
Displaying
Command
Function
show cwmp configuration
Displays the CWMP configuration.
show cwmp status
Displays the CWMP running status.