Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
Usage Guide
-
 Configuring an SSID
 For a FAT-AP to provide WLAN service, you must configure an SSID. Run the ssid command to configure the SSID of
a specified WLAN.
 If there are no special requirements, you can perform this configuration in the WLAN global configuration mode of the
AP equipment.
Command
ssid ssid-string
Parameter
Description
ssid-string: specifies an SSID string.
Defaults
-
Command
Mode
WLAN configuration mode
Usage Guide
-
 Configuring Whether to Broadcast SSIDs
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the WLAN
configuration mode of the AP equipment.
 If it is set to broadcast SSIDs, the AP regularly broadcasts SSID information. STAs use WNICs to search for the SSIDs
and discover the networks. If it is set not to broadcast SSIDs, the AP does not regularly broadcast SSID information.
STAs cannot find the SSIDs by using WNICs. In this case, SSIDs must be manually set on the STAs so that they can
access the corresponding network.
Command
broadcast-ssid
no broadcast-ssid
Parameter
Description
no: specifies whether to broadcast SSIDs.
Defaults
SSIDs are broadcasted.
Command
Mode
WLAN configuration mode
Usage Guide
-
 Configuring the Multicast Rate
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the WLAN
configuration mode of the AP equipment.
 The higher the multicast rate, the higher the network performance, the higher requirement for the signal-noise ratio, and
the higher the multicast packet loss ratio of wireless terminals. On the other hand, the lower the multicast rate, the lower

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English