Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
Command
ampdu { enable | disable }
Parameter
Description
enable: enables the A-MPDU aggregation mode.
disable: disables the A-MPDU aggregation mode.
Defaults
The A-MPDU aggregation mode is enabled.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the 11a Rate Set
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 Disabling a rate makes this rate unavailable. Disabling all rates makes STAs fail in access.
Command
rate-set 11a { mandatory | support | disable speed }
Parameter
Description
mandatory: indicates whether a rate is a mandatory rate.
support: indicates whether a rate is supported.
disable: indicates whether a rate is disabled.
speed: specifies a rate.
Defaults
6 Mbit/s, 9 Mbit/s and 12 Mbit/s are mandatory rates and all the other rates are supported rates.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the 11b Rate Set
 Optional.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 Disabling a rate makes this rate unavailable. Disabling all rates makes 11b STAs fail in access.
Command
rate-set 11b { mandatory | support | disable speed }
Parameter
Description
mandatory: indicates whether a rate is a mandatory rate.
support: indicates whether a rate is supported.
disable: indicates whether a rate is disabled.
speed: specifies a rate.
Defaults
1 Mbit/s, 2 Mbit/s, 5.5 Mbit/s and 11 Mbit/s are mandatory rates.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configure the 11g Rate Set
 Optional.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English