Configuration Guide Configuring FAT APs
If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
Disabling a rate makes this rate unavailable. Disabling all rates makes 11g STAs fail in access.
rate-set 11g { mandatory | support | disable speed }
mandatory: indicates whether a rate is a mandatory rate.
support: indicates whether a rate is supported.
disable: indicates whether a rate is disabled.
speed: specifies a rate.
1 Mbit/s, 2 Mbit/s, 5.5 Mbit/s and 11 Mbit/s are mandatory rates and all the other rates are supported rates.
dot11radio interface configuration mode
Configuring the 11n Rate Set
Optional.
If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
The higher the mcs, the higher the available rate.
rate-set 11n { mcs-mandatory | mcs-support index }
mcs-mandatory: indicates whether a rate is a mandatory mcs rate.
mcs-support: indicates whether a mcs rate is supported.
index: specifies a mcs rate.
The mcs is 7 for one stream, 15 for two streams, and 23 for three streams. All mandatory mcs is 0.
dot11radio interface configuration mode
Configuring the 11ac Rate Set
Optional.
If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
The higher the mcs, the higher the available rate.
rate-set 11ac { mcs-mandatory | mcs-support index }
mcs-mandatory: indicates whether a rate is a mandatory mcs rate.
mcs-support: indicates whether a mcs rate is supported.
index: specifies a mcs rate.
The mcs is 9 for one stream, 19 for two streams, and 29 for three streams. All mandatory mcs is 0.
dot11radio interface configuration mode