EasyManua.ls Logo

Ruijie RG-WLAN Series

Ruijie RG-WLAN Series
1243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration Guide Configuring Interfaces
Rxload is 1/255, Txload is 1/255
Ethernet attributes:
Medium-type is Copper
Last link state change time: 2013-12-20 13:55:20
Time duration since last link state change: 5 days, 5 hours, 17 minutes, 36 seconds
Priority is 0
admin duplex mode is AUTO, oper duplex is Unknown
admin speed is AUTO, oper speed is Unknown
Rxload is 1/255, Txload is 1/255
10 seconds input rate 0 bits/sec, 0 packets/sec
10 seconds output rate 0 bits/sec, 0 packets/sec
4 packets input, 408 bytes, 0 no buffer, 0 dropped
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
4 packets output, 408 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
B
B# show interfaces gigabitEthernet 0/1
Index(dec):1 (hex):1
GigabitEthernet 0/1 is administratively down , line protocol is DOWN
Hardware is PQ3 TSEC GIGABIT ETHERNET CONTROLLER GigabitEthernet, address is 00d0.f8fb.5945 (bia
00d0.f8fb.5945)
Interface address is: 192.168.1.2/24
ARP type: ARPA,ARP Timeout: 3600 seconds
Interface IPv6 address is:
No IPv6 address
MTU 1500 bytes, BW 1000000 Kbit
Encapsulation protocol is Ethernet-II, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Rxload is 1/255, Txload is 1/255
Ethernet attributes:

Table of Contents

Other manuals for Ruijie RG-WLAN Series

Related product manuals