Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring PPPoE Client
6.4.1 Configuring Basic Functions of the PPPoE Client
6.4.1.1 Networking Requirements
 The device initiates PPPoE negotiation, and completes the negotiation process, protocol keepalive, and protocol
termination.
 The device obtains Internet access capability after the negotiation is complete, and starts to forward a data flow which is
routed to the dialer interface.
6.4.1.2 Notes
 After the kernel module is uninstalled, users can still perform configuration management but negotiation and data flow
forwarding cannot be performed.
6.4.1.3 Configuration Steps
Enabling the PPPoE Client Function
 The configuration is mandatory.
 Perform this configuration in Ethernet interface configuration mode.
 Enable the PPPoE client function.
Binding a Logical Dialer Pool and Specifying the Dialing Mode
 The configuration is mandatory.
 Perform this configuration in Ethernet interface configuration mode.
 Bind the Ethernet interface to a specific logical dialer pool and specify the dialer mode.
Adding a Specific Logical Interface and Entering the Configuration Mode of the Logical Interface
 The configuration is mandatory.
 Perform this configuration in global configuration mode.
 Add a specific logical interface and enter its configuration mode.
Configuring the Way of Acquiring the IP Address of the Logical Interface
 The configuration is mandatory.
 Perform this configuration in logical interface configuration mode.
 Configure the way of acquiring the IP address of the logical interface.
Associating a Dialer Pool

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English