Ruijie RG-WLAN Series - Page 333

Configuration Guide Configuring PPPoE Client
Defining a Dialer Triggering Rule
 The configuration is mandatory.
 Perform this configuration in global configuration mode.
 Define a dialer triggering rule.
Verification
 Check whether the dialer interface has acquired an IP address.
 Check whether a correct dialer interface route entry has been established on the device.
6.4.1.4 Related Commands
Enabling the PPPoE Client Function
Command Syntax
pppoe enable
Parameter
Description
N/A
Command Mode
Interface configuration mode
Configuration
Usage
The interface on which the PPPoE client will be enabled must be a WAN Ethernet interface.
Binding a Logical Dialer Pool and Specifying the Dialing Mode
Command Syntax
pppoe-client dial-pool-number number { dial-on-demand | no-ddr }
Parameter
Description
number: number of the dialer pool
Command Mode
Interface configuration mode
Configuration
Usage
The PPPoE client function must be enabled on the interface first.
Adding a Specific Logical Interface and Entering its Configuration Mode
Command Syntax
interface dialer dialer-number
Parameter
Description
dialer-number: interface number
Command Mode
Global configuration mode
Configuration
Usage
N/A
Configuring the Way of Acquiring the IP Address of the Logical Interface
Command Syntax
ip address { negotiate | ip-addr subnet-mask }
Parameter
ip-addr: manually configured IP address