Ruijie RG-WLAN Series - Page 351

Configuration Guide Configuring IP Addresses and Services
1.4 Configuration
The IPv4 functions of Ping and Traceroute are not supported on AP110-W.
Configuration
Description and Command
Configuring the IP Addresses
of an Interface
(Mandatory) It is used to configure an IP address and allow the IP protocol to run on an
interface.
ip address
Manually configures the IP address of an
interface.
ip address negotiate
Obtains the IP address of an interface
through PPP negotiation.
ip unnumbered
Borrows an IP address from another
interface.
Configuring Broadcast
Forwarding
(Optional) It is used to set an IP broadcast address and enable directed broadcast
forwarding.
ip broadcast-address
Configures an IP broadcast address.
ip directed-broadcast
Enables directed broadcast forwarding.
Configuring ICMP
Forwarding
(Optional) It is used to enable ICMP packet forwarding.
ip unreachables
Enables ICMP unreachable messages and
host unreachable messages.
ip redirects
Enables ICMP redirection messages.
ip mask-reply
Enables ICMP mask response messages.
Configuring the Transmission
Rate of ICMP Error Packets
Optional.
ip icmp error-interval DF
Configures the transmission rate of ICMP
destination unreachable packets triggered
by the DF bit in the IP header.
ip icmp error-interval
Configures the transmission rate of ICMP
error packets and ICMP redirection packets.
Setting the IP MTU
(Optional) It is used to configure the IP MTU on an interface.
ip mtu
Sets the MTU value.
Setting the IP TTL
(Optional) It is used to configure the TTL of unicast packets and broadcast packets.
ip ttl
Sets the TTL value.
Configuring an IP Source
Route
(Optional) It is used to check the source routes.
ip source-route
Enables the IP source route function.