Configuration Guide Configuring DHCPConfiguring DHCP
Configures a NetBIOS node type on a
client.
Configures an alarm threshold of an
address pool.
Configures a user-defined option.
Enables or disables an address pool.
Adds a trusted ARP while assigning
addresses from a pool.
Configuring Static IP Address
(Optional) It is used to statically assign an IP address to a client
.
Configures an address pool name and
enters address pool configuration mode.
Configures the IP address and subnet
mask of a client host.
Configures a client hardware address.
Configures a unique client identifier.
Configures a client name.
Configuring Address Management
Based on Vlan/Port
(Optional) It is used to plan IP range requested by DHCP clients from
different vlan+port/vlan.
Enter AM configuration mode.
Configure default AM rule.
Configure AM rule based on
vlan+port/vlan.
Configuring Global Properties of
DHCP Server
(Optional) It is used to configure related properties of a DHCP server.
Configures an excluded IP address.
Configures Compulsory NAK reply by a
DHCP server.
ip dhcp monitor-vrrp-state
Configures VRRP status monitoring.
Configures a ping timeout.
Configures a DHCP server to refresh
trusted ARPs.
ip dhcp server arp-detect
Configures a DHCP server to detect user
offline.
 Configuring DHCP Relay
Configuring Basic DHCP Relay
Functions
(Mandatory) It is used to enable DHCP Relay.
Configures an IP Address of a DHCP
Server.