Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring DHCPv6
Ruijie#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#interface vlan 1
Ruijie(config-if)#ipv6 dhcp relay destination 3001::2
Ruijie(config-if)#ipv6 dhcp relay destination ff02::1:2 vlan 2
Verification
Run the show ipv6 dhcp relay destination all command to display the configured destination addresses.
Interface:VLAN 1
Destination address(es) Output Interface
3001::2
ff02::1:2 VLAN 2
Common Errors
 The configuration is performed on other interfaces than the Switch Virtual Interface (SVI), routed port and L3 AP port.
5.4.3 Configuring the DHCPv6 Client
Configuration Effect
 Enable a device to automatically request IPv6 addresses or related parameters from a server.
Notes
 The configuration must be performed on layer-3 interfaces.
The DHCPv6 client function is not supported on AP110-W or AP120-W.
Configuration Steps
 Enabling the DHCPv6 Client and Requesting IANA Addresses
 Mandatory.
 Unless otherwise specified, you should enable the DHCPv6 client address request function on all devices that need to
request addresses.
 Enabling the DHCPv6 Client and Requesting Address Prefixes
 Mandatory.
 Unless otherwise specified, you should enable the DHCPv6 client prefix request function on all devices that need to
request prefixes.
 Enabling the Stateless Service of the DHCPv6 Client

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English