EasyManua.ls Logo

Ruijie RG-WLAN Series - Page 52

Ruijie RG-WLAN Series
1243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration Guide Configuring FSS
Configuratio
n Steps
Configure the frequency spectrum scanning precision for video bridges as 2.
Ruijie# configure terminal
Ruijie(config)# spectral enable
Ruijie(config)# spectral stability vbr 2
Ruijie(config)# end
Verification
Run the show running-config command to verify the frequency spectrum scanning precision on the
target AP.
spectral stability vbr 2
Common Errors
FSS is not enabled.
This command is used in the all AP configuration mode.
4.4.3 Configuring the Frequency Spectrum Scanning Duration
Configuration Effect
Change the duration required for one cycle of frequency spectrum scanning, 5 ms by default and ranging 1-100 ms.
A longer scanning duration leads to a higher probability of locating interferences but a bigger influence on normal
communication of the AP.
Notes
FSS must be enabled.
Configuring the Frequency Spectrum Scanning Duration
Mandatory
The scanning duration is configured in global configuration mode. If there are no special requirements, the default
value can be used.
Command
spectral period num
Parameter
Description
num: scanning duration, ranging 1-100 ms, 5 ms by default.
Defaults
5
Command
Mode
Global configuration mode
Usage Guide
If there are no special requirements, the default value can be used.
Verification
Run the show running-config command to verify that the frequency spectrum scanning duration is configured on the
target AP.

Table of Contents

Other manuals for Ruijie RG-WLAN Series

Related product manuals