Ruijie RG-WLAN Series - Page 57

Configuration Guide Configuring Wireless Location
 The commands for configuring the IP address and PID are wlocation ae-ip ip-address and wlocation ae-port port
respectively.
Command
wlocation ae-ip ip-address
Parameter
Description
ip-address: IP address of the Locator
Defaults
No IP address is configured for the Locator. The AE server's default IP address is 0.0.0.0.
Command
Mode
Wlocation configuration mode
Usage Guide
N/A
Command
wlocation ae-port port
Parameter
Description
port: PID of the Locator
Defaults
The default PID is 12092.
Command
Mode
Wlocation configuration mode
Usage Guide
N/A
 Enabling MU or TAG Location
 Mandatory.
 To enable WL on an AP, you need to enable WL for MUs or TAGs. The configuration depends on the scenario and
the STA to be located.
Command
wlocation mu enable
Parameter
Description
N/A
Defaults
MU location is disabled.
Command
Mode
Wlocation configuration mode
Usage Guide
Both MU and TAG locations can be enabled at the same time.
Command
wlocation tag enable
Parameter
Description
N/A
Defaults
TAG location is disabled.
Command
Mode
Wlocation configuration mode
Usage Guide
Both MU and TAG locations can be enabled at the same time.
 Configuring the Interval for Sending MU or TAG Location Information
 Optional.
 It is used to adjust the interval for sending location information. Except as otherwise noted, the default value is
applicable.