Ruijie RG-WLAN Series - Page 58

Configuration Guide Configuring Wireless Location
 In the scenarios with a lot of STAs to be located, reduce the interval to avoid information losses. (An AP can cache
500 to 700 pieces of location information.)
Command
wlocation send-mu-time interval
Parameter
Description
interval: time interval, ranging from 100 to 5,000 ms
Defaults
The default interval is 300 ms.
Command
Mode
Wlocation configuration mode
Usage Guide
N/A
Command
wlocation send-tag-time interval
Parameter
Description
interval: time interval, ranging from 100 to 5,000 ms
Defaults
The default interval is 300 ms.
Command
Mode
Wlocation configuration mode
Usage Guide
N/A
 Enabling MU Location Report
 Optional.
 The Locator does not intercommunicate with APs which directly send collected MU location information, for example,
through the NAT network. Except as otherwise noted, the default value is applicable.
Command
wlocation mu report enable
Parameter
Description
N/A
Defaults
N/A
Command
Mode
Wlocation configuration mode
Usage Guide
With this function enabled, the handshake process of the protocol is ignored except through the NAT.
 Enabling TAG Location Report
 Optional.
 The Locator does not intercommunicate with APs which directly send collected TAG location information, for
example, through the NAT network. Except as otherwise noted, the default value is applicable.
Command
wlocation tag report enable
Parameter
Description
N/A
Defaults
Tag location report is disabled by default.
Command
Mode
Wlocation configuration mode
Usage Guide
With this function enabled, the handshake process of the protocol is ignored except through the NAT.
 Simplifying MU Location Information